Hardware connectors are the key.
Hardware connectors are the most intuitive quality standard. Good hardware must switch freely, without noise, and without peeling off the surface coating. The hardware of some high-end panel furniture is imported, and foreign language signs can be found on it. The metal parts are required to be dexterous, smooth, and the surface is well electroplated, free of rust, burrs, etc., the matching parts must have high precision, and the open-type connectors must be flexible in rotation.
Edge banding affects quality
Look carefully for the flaws, the quality of the edge banding greatly affects the quality of the furniture. The first is the pros and cons of the edge banding materials, and the second is to pay attention to whether the edge banding is uneven or warped. A good edge banding should fit tightly with the whole board.
A closer look at the quality of the board
Check carefully whether the glue applied to the decorative parts on the edges and surfaces of the board is even, whether the bonding is firm, whether the trimming is flat and smooth, whether the end faces of visible parts such as the side panels, door panels, drawer panels and other visible parts of the side panels, door panels, drawer panels, etc. are edge-sealed. No adhesion marks can be felt on the edges of the well-decorated panels.
The assembly combination mainly depends on whether the grooves at the drilled holes are delicate and tidy, whether the connectors are firm after installation, whether there is a gap in the T-shaped seam after the plane and the end surface are connected, and whether there is any looseness when pushing by hand.
Standard size
At present, the furniture on the market is mainly based on complete sets of bedroom furniture and office furniture, and there are also some products such as functional cabinets. The national standards for the size of furniture have regulations and requirements.
For example, it is stipulated that the depth of the space in the hanging closet should be greater than or equal to 530mm, the height of table furniture should be greater than or equal to 680mm to 760mm, and the clearance height between bookcases should be greater than or equal to 230mm to 310mm. If the furniture is smaller than the specified size, it will cause a lot of inconvenience when used.
