In the making process of furniture, to prolong service life, and avoid to be pricked by wood, general meeting is furniture burnish, brush lacquer, so how is the craft flow of furniture paint?Lacquer on furniture is a quite crucial working procedure actually, it is affecting the quality of furniture directly already, affect the appearance of furniture again.Therefore, most of the furniture factory, just this process should go through several inspection procedures.Below, we see the specific craft flow of furniture paint carefully.
1, furniture sand inspection
Sand inspection is the prelude of the whole paint quality, the quality of sand inspection directly affects the quality of the whole product, is one of the indispensable procedures of the paint workshop.To product inspection before sand on the need for the product test procedure, the texture more deep, have a little missing Angle or local peel place for ash handling, then use flat sanding machine for flat products with 240 # emery paper to grind, some local product cannot use machine operation can use hand or homemade tool grinding.After finishing the grinding, sand paper of 400# is used for the second grinding until it meets the quality acceptance standard of this process.
2. Paint the furniture
The purpose of rubbing color is to better show the texture of the material, texture, can correct the color difference of the material appropriately, improve the efficiency of color repair.In the process of wiping the need for operators to be able to accurately distinguish different color difference, if there is a large color difference need to recolor or color, until the color match.But it is important to note that each product in the process of wiping must be thoroughly clean the floating color, so as not to cause color difference between products.
3, furniture bottom oil coating
The purpose of spraying bottom oil is to increase the thickness of the paint film of furniture and improve the flatness in the next operation.Usually in the furniture industry with the most extensive fully enclosed, fully enclosed normal for the spray bottom oil three times, but each time the need for the next process to grind.From the deployment of paint to spraying quality requirements are very high, the work process is generally not too thick for the first coating requirements, but the coating behind to increase the number of times with The Times of spraying, every time to do spraying evenly, can not appear the phenomenon of hanging.
4. Furniture oil mill
The quality requirement of oil mill is very high, the effect that oil mill comes out affects the quality of a few working procedure directly next, oil mill also is the working procedure that appears the problem most in furniture paint making process.
5. Color furniture
The biggest effect that repairs a color to the product is to make the color of each product is consistent, to planar job product (wait like mesa, facade) spray commonly 4 times advisable.The color requirement of flank and front wants consistent, opposite work product (be like eat chair, cabinet body) want to spray to the place that is not easy to arrive first first spray, should do well to union place to receive gun range, cannot appear chromatic aberration.After finishing the spraying operation of each product, the color plate shall be compared, and the color shall be the same before the handover.
6, furniture surface oil spraying
Face oil is the last working procedure in making paint craft, also be the last working procedure in whole furniture making craft.Surface oil spraying quality, there are mainly the following two factors, environmental factors and human factors.Environmental factors refers to the environmental hygiene in the spray room is not clean enough to lead to the paint after the dry particles too much, feel bad.The human factor refers to the paint surface spray is not uniform, hanging and not spray in place parts and rough parts.Really don't say don't know, the working procedure of original furniture paint is so complex, so many exquisite.This also explains from another side, why our DIY paint products are always difficult to meet the relevant requirements, in a sense, strict, complex process is an important guarantee of quality.
