Hotel Furniture Purchasing Knowledge And Maintenance Tactics

1, whether the hotel furniture materials are reasonable

Different hotel furniture, surface materials are different.Be like the leg child of desk, chair, ark, the requirement uses hard miscellaneous wood, more solid, can bear weight, and interior uses makings to be able to use other material;The thickness of the legs of the wardrobe should reach 2.5cm, too thick will be clumsy, thin and easy to bend deformation;The cabinet of kitchen, toilet cannot do with fibreboard, and should use three-ply board, because fibreboard encounters water to be able to expand, damage;The table should be washable.Found wood insect eye, drop foam, drying is not thorough.ZHANGZHOU OCA FURNITURE beauty furniture suggests you check the surface, even open the cupboard door, drawer door to see inside the material has decayed, can use fingernail to pinch a pinch, pinched went in to explain inside material decayed.After opening cabinet door, use nose to smell, if blunt nose, dazzling, tear, explain formaldehyde content in cement is too high, can be harmful to human body.

2. Wood moisture content shall not exceed 12%

Hotel furniture moisture content shall not exceed 12%, moisture content is high, wood is easy to warp, deformation.General consumers buy, there is no test equipment, can take the method of hand touch, touch the bottom surface of the hotel furniture or there is no paint inside, if the feeling of moisture, then moisture content at least more than 50%, can not be used.Beijing and Junxin beauty furniture suggest you another way is to wood not painted sprinkle a little water, if the slow or not Yin Yin, indicating high moisture content.

3. Whether the hotel furniture structure is solid

Small pieces of hotel furniture, such as chairs, stools, clothes racks in the selection can be dragged on the cement floor, gently fell down, the sound is clear, that the quality is better;If the voice is hoarse, there is a crack or crack noise, indicating that the mortise and tenon is not tight, the structure is not strong.Desk, table can shake shake with the hand, see steady not steady.The sofa can sit, if sit on a movement on the squeak wiggle ring, a shake shake, is the nail live, not long time.The leg ministry such as square table, bar table, chair should have 4 triangular clip, have fixed effect, can turn desk and chair upside down to look when choosing, pack cloth chair can touch with the hand.

4. Whether the four feet of hotel furniture are flat

This point on the ground a shake will know, some hotel furniture only three legs landing.Take a look at the table is straight, can not bow back or collapse the waist.The table top is convex, and the glass panel will rotate;The table top is recessed and the glass panel breaks when pressed.Beijing and Junxinmei furniture suggested that you pay attention to check the cabinet door, the split seam of the drawer should not be too large, pay attention to horizontal flat firm straight, the door can not drop.

5, veneer hotel furniture patchwork lax

No matter stick wood veneer, PVC or stick pre-paint paper, pay attention to whether the leather paste is smooth, there is no bulge, bubble, patchwork lax phenomenon.Check to look at the light, do not look out of the light.The furniture of the hotel is damaged and can only be used for two years.In the case of wood veneer, planed veneer is better than rotary veneer.Beijing and Junxinmei furniture suggests that you identify the two methods is to look at the pattern of wood, veneer wood texture planed straight and dense, veneer pattern zigzag and sparse.Veneer hotel furniture particleboard, the landing part must be sealed edge, not sealed edge board will absorb moisture, swell and damage.General veneer hotel furniture corner is easy to become cocked, you can use your hand to pick the corner, if a button up, it is a problem with glue.

Two. Hotel furniture cleaning and maintenance practical tactics

1. Clean your cloth

When undertaking cleanness maintenance to furniture, must decide the dishcloth that uses first is clean.After cleaning or wiping the dust, be sure to turn over or replace it with a clean rag.Don't be lazy and reuse the dirty side again and again. This will only cause the dirt to rub against the surface of the furniture repeatedly, and will damage the bright surface of the furniture instead.

2. Choose the right nursing agent

Want to maintain the original brightness of furniture, there are two kinds of furniture care spray wax and cleaning maintenance agent.The former basically is aimed at the furniture such as board of material of all sorts of woodiness, polyester, paint, fire prevention, have jasmine and lemon two kinds of different and pure and fresh fragrance.Beijing and Junxinmei furniture suggest that the latter is suitable for all kinds of furniture made of wood, glass, synthetic wood or plywood, especially for mixed materials.Therefore, if you can use both cleaning and nursing effect of the maintenance products, you can save a lot of valuable time.Before the use of wax spray and cleaning maintenance agent, it is better to shake it well first, and then hold the spray can, with a 45 degree Angle, so that the liquid content in the tank can be completely released under the state of not breaking the pressure.Beijing and Junxin beauty furniture suggest you after the dry dishcloth in the distance of about 15 centimeters gently spray, so to wipe the furniture, can have a very good cleaning and maintenance effect.Also, wash and dry the cloth after use.As to the furniture that contains cloth material to pledge, if cloth art sofa, recreational cushion for leaning on, the cleanness that can use clean carpet maintains agent.When using, suck dust with cleaner first, spray carpet cleaner a few times again go up in wet cloth wipe can.