1. Opening measurement: Wooden doors shall be measured prior to the design, production and installation of guest hotel furniture.Measurements shall be made according to the dimensions of the finished floor and wall materials.If floor and wall work is not completed, the thickness of the decorative materials should be retained.
2. Confirm the width of the opening of the door: measure the size of the opening horizontally, select 5 measuring points for measurement, measure through the corresponding measurement of vertical and horizontal, and take the minimum value as the width of the opening.If the measured value of the remaining 4 points is greater than the minimum value, more than 20mm, the hole shall be adjusted as required.
3, the confirmation of the door height: the measurement method of the door frame height and width is basically the same.Measure the size of the hole vertically, select 3 measuring points for measurement, and take the minimum value as the width of the door.When the measured size reaches the height of the unlaid floor, please pay attention to the size of the hanging Angle.If the measured value of the remaining two points is greater than the minimum value of 10 mm, the holes shall be adjusted as required.
4, confirm the wall thickness of the door: try to measure the wall thickness of the door frame, a door shall not be less than 7 minutes.If the measured value of the remaining 6 points is less than the maximum value, more than 5mm, the hole should be adjusted as required.
5. Confirm the opening size of the single-side wall door:
(1) The opening of the single-sided door corresponds to the thickness of the flat wall, and the left and right sides are asymmetric structures.Add part of the wall to the flat wall, stabilize the door frame, and assemble the decorative strip of the door frame.For 60 mm door cover lines, the wall width should be increased by 35-40 mm;For 80 mm wide door cover lines, the wall width needs to be increased by 55-60 mm.This kind of door cover cable must be close to the wall surface, do not increase the width of the wall, otherwise it will affect the installation of door cover cable.
(2) The calculation of the width and size of the door wall should be measured in the standard surface after adding the wall, the measurement method is the same as the above steps.
Note: The exterior line of the door cover line is taken as the reference here, and one side is fixed.You have to think about preserving space when you do the calculation.
, shortcut: in the case of not increasing the wall, on the flat wall according to the corresponding width of the wall nail 2 35mm solid wood stick can also solve this problem.
6. Confirm that the opening size of the sliding door is the same as the above method.
